[Solved] Multipass heat exchangers are used

McqMate

Q.	Multipass heat exchangers are used
A.	Because of simplicity of fabrication
B.	For low heat load
C.	To obtain higher heat transfer co-efficient and shorter tube
D.	To reduce the pressure drop
Answer» C. To obtain higher heat transfer co-efficient and shorter tube

2.9k

0

Do you find this helpful?

21

View all MCQs in

Heat Transfer (HT)

Discussion

No comments yet

Related MCQs

Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.
'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a www.objectivebooks.com
For a multipass shell and tube heat exchanger, the LMTD correction factor is always
In case of a multipass shell and tube heat exchanger, the temperature drop in the fluid
The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is
Which of the following parameters is increased by use of finned tube in a multipass shell and tube heat exchanger?
In a multipass shell and tube heat exchanger, tube side return pressure loss is equal to __________ the velocity head.