In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.

Related MCQs

• 1000 Kg of liquid at 30°C in a well stirred vessel has to be heated to 120°C, using immersed coils carrying condensing steam at 150°C. The area of the steam coils is 1.2 m2 and the overall heat transfer co-efficient to the liquid is 1500 W/m2.°C. Assuming negligible heat loss to the surrounding and specific heat capacity of the liquid to be 4 kJ/kg.°C, the time taken for the liquid to reach desired temperature will be
• In a heat exchanger with steam outside the tubes, a liquid gets heated to 45°C, when its flow velocity in the tubes is 2 m/s. If the flow velocity is reduced to 1 m/s, other things remaining the same, the temperature of the exit liquid will be
• A long iron rod initially at a temperature of 20°C has one end dipped in boiling water (100°C) at time, t = 0. The curved surface of the rod is insulated so that heat conduction is one dimensional in the axial direction. The temperature at a distance 100 mm from the dipped end becomes 40°C at time, t = 200 s. The same temperature is achieved at a distance of 200 mm from the dipped end at time
• In case of __________ boiling, the bubbles formed on a submerged hot surface get absorbed in the mass of the liquid.
• Heat flux increases with temperature drop beyond the Leiden frost point in the plot of heat flux vs. temperature drop for a boiling liquid, because
• A liquid is boiling in a a air tight vessel. Using an exhaust tube, the vapour is pumped out at a faster rate. What happens to the liquid?
• If the bubbles formed on a submerged hot surface get absorbed in the mass of liquid, the process of boiling is termed as
• When vaporisation takes place through a blanketting film of gas, the phenomenon is termed as __________ boiling.
• A hollow sphere and a solid sphere of the same material and equal radii are heated to the same temperature. In this case,
• Three rods one made of glass, one of pure aluminium and one made of wrought iron are heated to 150?C. All the rods are 15 mm in diameter and 300 mm long. The lowest temperature at the free end of the rods will occur in case of