[Solved] On eccentrically loaded columns, the equivalent axial load may be obtained by

Q.	On eccentrically loaded columns, the equivalent axial load may be obtained by
A.	Adding the axial load, eccentric load, the product of the bending moment due to eccentric load and the appropriate bending factor
B.	Adding the axial load and eccentric load and subtracting the product of bending moment and appropriate bending factor
C.	Dividing the sum of axial load and eccentric load by the product of the bending moment and appropriate bending factor
D.	None of these
Answer» A. Adding the axial load, eccentric load, the product of the bending moment due to eccentric load and the appropriate bending factor

Do you find this helpful?

View all MCQs in

Design of Steel Structures

Discussion

No comments yet

Related MCQs

The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
Battening is preferable when the (i) Column carries axial load only (ii) Space between the two main components is not very large (iii) Column is eccentrically loaded The correct answer is
For eccentrically loaded columns, the bending factor is
The equivalent axial load may be defined as the load which produces a stress equal to
An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2 , the thickness (t) of the slab base, is
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which moment in any rivet.)
In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
When the ratio of the moment M to axial load P is greater than L/6, the resultant of the compressive bearing pressure which acts at a distance Y from one side, is given by
To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be