The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).

Related MCQs

• The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).
• The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
• The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is
• As compared to field rivets, the shop rivets are
• If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by
• The minimum pitch of rivet holes of diameter d should not be less than
• Minimum pitch of the rivets shall not be less than (Where d is gross diameter of rivet)
• In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
• The strength of ISA 125 = 75 × 10 mm used as a tie member with its longer leg connected at the ends by 27 mm diameter rivets, is
• If p and d are pitch and gross diameter of rivets, the efficiency ( ) of the riveted joint, is given by