Which of the following does not belong to the instruments of plane table?

Related MCQs

• After fixing the plane table to the tripod, the main operations which are needed at each plane table station are i) levelling ii) orientation iii) centering The correct sequence of these operations is
• Which of the following acts as an advantage of plane table surveying?
• The plotting of small areas which can be commanded from a single station, is usually done on the plane table by the method of
• The size of a plane table is
• The instrument used for accurate centering in plane table survey is
• The methods used for locating the plane table stations are i) radiation ii) traversing iii) intersection iv) resection The correct answer is
• Plotting of inaccessible points on a plane table, is done by
• The operation of revolving a plane table about its vertical axis so that all lines on the sheet become parallel to corresponding lines on the ground, is known
• In plane table surveying, plotting and recording of values are done simultaneously.
• The strength of 'fix' of a plane table from three known points is good if the middle station is