Hudson's formula gives the dead weight of a truss bridge as a function of

Related MCQs

• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
• To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be
• The portal bracing in a truss bridge is used to
• In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
• In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
• If the floor is supported at or near the bottom but top chords of a bridge is not braced, then the bridge is called
• If the floor is supported at or near the bottom but top chords of a bridge is not braced, then the bridge is called
• On steel structures the dead load is the weight of
• Maximum permissible slenderness ratio of a member normally acting as a tie in a roof truss, is