In plastic analysis, the shape factor for circular sections, is

Related MCQs

• The statical method of plastic analysis satisfies
• The mechanism method of plastic analysis satisfies
• Which of the following conditions is to be satisfied both in elastic and plastic analysis?
• As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
• In case of timber structures, the form factor for solid circular cross-section is taken as
• Shape factor is a property which depends
• The shape factor of an isosceles triangle for bending about the axis parallel to the base is:
• The shape factor of an isosceles triangle for bending about the axis parallel to the base is:
• The ratio of plastic section modulus to elastic section modulus
• The moment-curvature relation at a plastic hinge is