When the work is done on the gases, which of the following effect is observed on the turning moment diagram?

Related MCQs

• In the turning moment diagram of a multicylinder engine, the work done during exhaust stroke is by  
• Describing the behavior characteristics through block diagram is done in          
• Calculate the work done per minute by a punch tool making 20 working strokes per min when a 30 mm diametre hole is punched in 5 mm thick plate with ultimate shear strength og 450 Mpa in each stroke.
• In the following picture the G is the center of gravity, the quantity h is known as the “offset”. I is the moment of inertia and k is the radius of gyration. Offset’s value is given by?
• Which of the following represents the output of Hall Effect transducer?
• 45 N/mm2. The connecting rod length between centres is 1.2 m and the cylinder bore is 0.5 m. If the engine runs at 250 r.p.m. and if the effect of piston rod diameter is neglected, calculate the net load on piston.
• What is not the effect of unbalanced forces?
• The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes a turn to the left. The effect of gyroscopic couple on the aeroplane will be
• The rotor of a ship rotates in clockwise direction when viewed from stern and the ship takes a right turn. The effect of gyroscopic couple acting on it will be to raise the stern and lower the bow.
• When the pitching of a ship is upward, the effect of gyroscopic couple acting on it will be