The flux density of the magnetism induced by a coil is affected by:

Related MCQs

• A radiograph is made using film X with an exposure of 10 mA-min. Film density obtained in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
• A radiograph is made using film X with an exposure of 10 mA-min. Film density in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
• Flux density is a measure of the number of magnetic flux lines perpendicular to an area of cross-section. If a discontinuity is in the plane of the unit area, the strongest magnetic article indication will be formed when the discontinuity is:
• The formula, NI = 45000/(L/D), gives proper magnetising current for a coil, regardless of coil size as long as:
• Magnetic flux density is zero at:
• Magnetic flux density is highest at:
• The unit usually used to denote flux density is the:
• The unit usually used to denote flux density is the:
• The density of the radiograph through the weld area is 3.2 while the density in the base metal is 2.9. This would probably indicate:
• A radiographic exposure with 3700 GBq (100 Ci) source of Ir-192 using source to film distance of 60 cm results in a radiation intensity of 0.12 Gy/h (11.8 R/h) and a radiographic density of 2.5. The intensity of radiation needed to obtain the same density when the source to film distance is changed to120 cm is: