If a power amplifier has an output power of 10 W, and an amplifier gain of 16.4 dB, then the input drive power is:

Related MCQs

• If the output power of an amplifier is 10 V, and the input power supplied to the amplifier is 0.229 V given that the DC voltage used is
• Amplifier efficiency is the ratio of RF output power to DC input power. This parameter determines the performance of an amplifier.
• Along with a differential amplifier, 1800 hybrid is used both at the input and output.
• In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:
• The klystron tube used in a klystron amplifier is a                    type beam amplifier.
• For a Wilkinson power divider of insertion loss L and the coupler is matched to the external circuitry, and then the gain of the coupler in terms of insertion loss is:
• If an antenna has a directivity of 16 and radiation efficiency of 0.9, then the gain of the antenna is:
• If the power input to an antenna is 100 mW and if the radiated power is measured to be 90 mW, then the efficiency of the antenna is:
• A class B amplifier consists of                 transistors in order to conduct the input signal over the entire cycle.
•                          uses balanced input and output, meaning that there are 2 signal lines, with opposite polarity at each port.