To flatten the gain response of a transistor:

Related MCQs

• In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:
•                        amplifiers are linear circuits, where the transistor is biased to conduct over the entire range of the input signal cycle.
• Behavior of a transistor in power amplifiers is unpredictable at all input signal levels.
• For Colpitts oscillator, the capacitors C1 and C2 in the feedback network are 1 µF and 25 µF respectively. Then the β value of the transistor is:
• In transistor oscillators, the requirement of a negative resistance device is satisfied using a varactor diode.
• In transistor oscillators, FET and BJT are used. Instability is achieved by:
• If an antenna has a directivity of 16 and radiation efficiency of 0.9, then the gain of the antenna is:
• Gain of an antenna is always greater than the directivity of the antenna.
• What is the power radiated by the antenna with gain called as?
•              antennas have gain less than reflector antennas but have more lenient tolerance on surfaces.