Conductance is given by (where, x = thickness, A = heat flow area, K = thermal conductivity.)

Related MCQs

• A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2 .°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be
• There metal walls of same cross-sectional area having thermal conductivity in the ratio 1 : 2 : 4 transfer heat at the rate of 15000 kcal/hr. For same thickness of wall, the temperature deop will be in the ratio
• The face temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of wall material is 0.30 kcal/m-hr-?C. For a wall thickness of 20 cm, the rate of heat conduction per square meter of wall area will be
• The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator or as a heat pump between the same reservoirs. Then the coefficient of performance as a refrigerator (COP)R and the co-efficient of performance as a heat pump (COP)HP are
• The variation of thermal conductivity of a metal with temperature is often correlated using an expression of the form K = K0 + at, where, K is the thermal conductivity and T is the temperature (in °K). The units of 'a' in SI system will be
• For gases, the thermal conductivity increases with temperature rise. For liquids, with increase in concentration, its thermal conductivity generally
• If thermal conductivity of aluminium is say 100 units at 0?C, the thermal conductivity at 500?C will be closer to
• Resistance to heat flow by conduction is proportional to (where, t & ρ are thickness & density of the material respectively and A = area normal to the direction of heat flow.)
• In heat transfer, conductance equals conductivity (kcal/hr/sqm/°C/cm) divided by
• When analogy is drawn between heat flow and electricity flow in circuits, the heat flow of thermal circuits is equated in the electrical circuit against