What is the geometric mean of two heat transfer areas A1 and A2?

Related MCQs

• Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
• The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in laminar zone is related as
• A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2 .°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be
• Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
• The overall heat transfer co-efficient for a shell and tube heat exchanger for clean surfaces is U0 = 400 W/m2.K. The fouling factor after one year of operation is found to be hd0 = 2000W/m2.K. The overall heat transfer co-efficient at this time is
• For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area
• In case of heat transfer by conduction in a hollow cylinder, __________ mean area is used to calculate the heat transfer rate.
• Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Conduction heat transfer cannot take place
• Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface).
• A dimensionless heat transfer coefficient which gives a measure of the ratio of the heat transfer rate to the rate at which heat would be conducted within the fluid under a temperature gradient is known as