When a liquid and its vapour are in equilibrium at a certain pressure and temperature, then which of the following is required to identify the saturation state.

Related MCQs

• When the temperature of a liquid is less than the saturation temperature at the given pressure, the liquid is called compressed liquid.
• A piston –cylinder device contains 0.06m3 of saturated water vapour at 350 kPa pressure. Determine the temperature and mass of the vapour inside the cylinder.
• The temperature of feedwater leaving a heater is          the saturation temperature at steam extraction pressure.
• Which of the following is true?(here pa=partial pressure of dry air, pw=partial pressure of water vapour, p=atmospheric pressure)
• An application requires R-12 at −140°C. The triple-point temperature is −157°C. Find the pressure of the saturated vapour at the required condition.
• A rigid tank contains 10 kg of water at 90°C. If 8 kg of the water is in the liquid form and the rest is in the vapour form, determine the pressure in the tank.
• Considerfollowing options for a simple Rankine cycle i) increasing pressure at exist of turbine ii) increasing average temperature of heat addition iii) decreasing pressure at exit of turbine iv) superheating of steam v) decreasing pressure during superheating. Which combination of above will increase Rankine efficiency?
• A saturation state is a state from which a change of phase may occur
• The greater the temperature, the is the vapour pressure.
• The greater the temperature, the          is the vapour pressure.