Coefficient of friction is minimum at

Related MCQs

• Calculate the tension in the rope of pulley C. "The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm"
• If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is? "The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm"
• The ratio of the maximum fluctuation of energy to the ……. is called coefficient of fluctuation of energy.
• The coefficient of fluctuation of speed is the                    of maximum fluctuation of speed and the mean speed.
• If E = Mean kinetic energy of the flywheel, CS = Coefficient of fluctuation of speed and Δ E = Maximum fluctuation of energy, then
• Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)