The fundamental equation for viscous flow is given by ∆pbhᵌ/6µl where symbols have their usual meanings.

Related MCQs

• What is the expression of the bending equation?
• Why tolerances are given to the parts?
• Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
• If number of coils are 8 and wire diameter of spring 3mm, then solid length is given by?
• While designing shaft on the basis of torsional rigidity, angle of twist is given by?
• If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.
• The tensile stress in the flywheel rim due to the centrifugal force acting on the rim is given by
• Cast surfaces have good finishing.
• Sliding contact bearings, also called plain bearings have no problem of wear.
• Flexible shafts have        rigidity in torsion making them flexible.