[Solved] According to ASTM E709-95 in using prods having a spacing of 19 mm (3/4 inches) and above, the magnetizing current shall be:

Q.	According to ASTM E709-95 in using prods having a spacing of 19 mm (3/4 inches) and above, the magnetizing current shall be:
A.	From 90 to 110 A/25 mm (1 inch)
B.	From 100 to 125 A/25 mm (1 inch)
C.	From 90 to 120 A/ 25 mm (1 inch)
D.	From 100 to 200 A/25 mm (1 inch)
Answer» B. From 100 to 125 A/25 mm (1 inch)

3.3k

Do you find this helpful?

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

According to ASTM E709-95 in using prod technique on a 50 mm thickness plate with a prod spacing of 101 mm (4 inches), current shall be selected in the following range:
How many turns of a coil will be needed to establish a longitudinal field in a steel shaft that is 22.86 cm (9 inches) long and 7.62 cm (3 inches) in diameter? 3000 amperes magnetizing current is available, it is desired to magnetize the part in accordance with the formula NI = 45,000/(L/D):
A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
A bar that is 5 cm (2 inches) by 10 cm (4 inches) by 30.5 cm (12 inches) is being magnetized in the circular direction. About how many amperes are required using the perimeter approach?
According to ASTM E709-95 with prod technique, the prods shall be tipped if the open circuit voltage is over:
According to ASTM E709-95 in using prod technique, prod spacing shall not exceed:
According to ASTM E709-95 and API, the UV intensity measured at a minimum of 38 cm (15 inches) at least shall not be less than:
A 7.6 cm (3 inches) thick test specimen is radiographed with a source having size of 1.3 cm (1/2 inch), the film is placed in contact with the test specimen. The source to film distance is 40.6 cm (16 inches).The geometric unsharpness obtained is:
In which magnetizing method is the current passed directly through the part, thereby setting up a magnetic field at right angles to the current flow?
According to ASTM E709-95 when fluorescent particles are used, the UV light intensity shall be above: