How many turns of a coil will be needed to establish a longitudinal field in a steel shaft that is 22.86 cm (9 inches) long and 7.62 cm (3 inches) in diameter? 3000 amperes magnetizing current is available, it is desired to magnetize the part in accordance with the formula NI = 45,000/(L/D):

Related MCQs

• What type of magnetization uses the formula: I = 45000/(L/D)N where I is the current in Amperes, N the number of turns of the magnetizing coil, L the length of the cylindrical test piece and D its diameter.
• How many ampere-turns are required to magnetize a part that is 40.6 cm (16 inches) long and 5 cm (2 inches) in diameter?
• For a 7.6 cm (3 inches) diameter bar how much current is needed to magnetize the bar for the detection of longitudinal discontinuities:
• A bar that is 5 cm (2 inches) by 10 cm (4 inches) by 30.5 cm (12 inches) is being magnetized in the circular direction. About how many amperes are required using the perimeter approach?
• With current flowing from + to - in a coil, a longitudinal field is created. Which of the following may be used to establish the direction of the magnetic field?
• A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
• In which magnetizing method is the current passed directly through the part, thereby setting up a magnetic field at right angles to the current flow?
• The formula, NI = 45000/(L/D), gives proper magnetising current for a coil, regardless of coil size as long as:
• According to ASTM E709-95 in using prods having a spacing of 19 mm (3/4 inches) and above, the magnetizing current shall be:
• For detection of longitudinal discontinuities a 7.6 cm (3 inches) diameter bar is magnetized in: