The capillary rise of water

Related MCQs

• Rise of water table above the ground surface causes
• The rise of water table below the foundation influences the bearing capacity of soil mainly by reducing
• Rise of water table in cohesion-less soils upto ground surface reduces the net ultimate bearing capacity approximately by
• The weight of a pycnometer containing 400 g sand and water full to the top is 2150 g. The weight of pycnometer full of clean water is 1950 g. If specific gravity of the soil is 2.5, the water content is
• Due to a rise in temperature, the viscosity and the unit weight of the percolating fluid are reduced to 60% and 90% respectively. If other things remain constant, the coefficient of permeability
• 260 g of wet soil was taken in a pycnometer jar of weight 400 g in order to find the moisture content in the soil, with specific gravity of soil particles 2.75. The weight of soil and remaining water filled in pycnometer without air bubbles was 1415 g and the weight of pycnometer filled with water alone was 1275 g. The moisture content in the soil is
• The total weight of a pycnometer with water and oven dried soil 20 ( g) is 1600 g. The pycnometer filled with water alone weighs 1500 g. The specific gravity of the soil, is
• Plasticity index is defined as the range of water content between
• You are given a sample of soil containing coarse grains to determine its water content, you will use
• If the water content of a fully saturated soil mass is 100%, then the voids ratio of the sample is