Rate of change of bending moment is equal to

Related MCQs

• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• The rate of change of bending moment is equal to
• Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• The relation between the bending moment and the moment of resistance e.g. M=fZ applies
• When there is no increase or decrease in shear force between two points, it indicates that there is no change in the bending moment between these points.