The elongation of circular tapered rod is given by…………. Where P=axial pull and d1, d2= diameters at two ends.

Related MCQs

• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• If percentage elongation of a certain specimen made of a material 'A' under tensile test is 30% and the percentage elongation of a specimen with same dimensions made of another material 'B' is 40%, then material 'B' is more ductile than material 'A'.
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
• Two bars of different materials and same size are subjected to the same tensile force. If the bars have unit elongation in the ratio of 2 : 5, then the ratio of modulus of elasticity of the two materials will be
• Two bars of sifferent materials are of the same size and are subjected to same tensile forces. If the bars have unit elongation in the ratio of 7 : 3, then the ratio of modulii of elasticity of the two materials is
• Of the two prismatic beams of same material, length and flexural strength, one is circular and other is square in cross-section. The ratio of weights of circular and square beams is