A steel rod of length is manufactured at a temperature 200C and its temperature increases upto 1350C.What are thermal stresses induced? E=200Gpa,α=12*10-6/0C

Related MCQs

• A steel rod of 3m is manufactured at 250C the temperature of rod is increases to 1250C. If free expansion is 3.6mm, what is the temperature stresses produced if 1.5mm expansion is permitted?
• A steel rod of 3m length is manufactured at 250C the temperature of this rod increases to 1250C. What is the free expansion? Take E=200Gpa, α=12*10-6/0C,diameter=12mm
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.
• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• If an axial force of 1 kN is applied to a rod of 100 mm2 cross section area, length 5 m and the modulus of elasticity of the material is 100 GPa, the change in length of the rod will be ___ .
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• A steel strip is welded to a copper strip of the same dimensions along the length. The coefficient of thermal expansion for copper is greater than that for steel. If temperature is increased, ___ .