A steel tube (E = 200 GPa) has an internal diameter of 40 mm thickness 10 mm and a length of 2 m. If it is subjected to an axial pull of 80 kN, the stress in the tube will be __ _MPa.

Related MCQs

• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be
• A steel tube (E= 200Gpa) has an internal diameter of 40 mm, thickness 10 mm and a length of 2 m. If it is subjected to an axial pull of 80 kN, the change in length of the tube will be __ _mm.
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _
• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of CD is mm.
• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of the composite rod is mm.
• A body is subjected to a direct tensile stress of 300 Mpa in one plane accompanied by a simple shear stress of 200 Mpa. The maximum normal stress will be
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.
• A piece of steel plate is subjected to perpendicular stresses of 50 Mpa and 30 Mpa both tensile. The normal stress is