The governor for steam turbine is driven by

Related MCQs

• A steam turbine in which a part of the steam turbine after partial expansion is used for process heating and the remaining steam is further expanded for power generation, is known as
• In a throttle governed single cylinder steam engine 5 I.H.P. is developed when steam consumption is 50 kg per hour and 2 I.H.P. is developed when the steam consumption is 26 kg per hour. The steam consumptions when the engine develops 4 I.H.P. will be
• For steam engine having a throttle governor, a straight line is obtained when the total weight of steam used per hour is plotted against the indicated horse power. This line is known as
• Excessive moisture in steam in a steam turbine is likely to result in
• Which of the following is a part of reciprocating steam engine and not a part of steam turbine plant?
• Reheating of steam for steam turbine cycle is done primarily to
• A gas turbine cycle operates through pressures ratio of 5. Air enters the compressor at atmospheric pressure and 25?C and entry to the turbine is at 800?C. The thermal efficiency of the plant has been found to be 37%. Now, if compressor and turbine efficiencies of 80% are taken into account, the value, of thermal efficiency will be
• The pressure of steam generated in a boiler as recorded by the Bourdon pressure gauge was 2.2 kg/sq-cm. If the barometer reads 774 mm of mercury the absolute pressure of steam would be
• Rankine cycle efficiency for fixed steam temperature of any volume upto critical temperature will be maximum for steam pressure of
• Steam leaves the steam nozzle at