In a lathe power feed is generally not available for

Related MCQs

• The included angle of a lathe centre is generally
• A right hand tool on lathe machine will cut efficiently while cutting
• While cutting double start threads of pitch 2 mm on a lathe, the cutting tool will advance by
• If the rake angle on a HSS lathe tool is 25 degrees the materials being machined is
• In lathe machine the chasing dial is used during
• In a lathe gear box if first four consecutive speed are 19, 30, 47, 74 rpm, the next speed would be
• Which of the following operation cannot be carried out on a lathe machine?
• Which of the following chucking device can be used on lathe?
• In a centre lathe gear box for changing spindle speeds the provision for speeds is made in
• At what rpm should a lathe be run to give a cutting speed of 25 m/min. When turning a rod of diameter 32 mm.