During the tensile test on a glass rod, the nature of stress section curve is

Related MCQs

• The stress strain curve for a glass rod during tensile test would exhibit
• A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be
• At a point in a steel member, the major principal stress is 2000 kg/cm2 and the minor principal stress is compressive. If the uni-axial tensile yield stress is 2500 kg/cm2, then the magnitude of the minor principal stress at which yielding will commence, according to the maximum shearing stress theory, is
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• When a body is subjected to a direct tensile stress (?), maximum normal stress is equal to the direct tensile stress.
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress is always a tensile stress where as the radial stress is a compressive stress
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.
• When a body is subjected to a direct tensile stress (?) in one plane, then normal stress on an oblique section of the body inclined at an angle ? to the normal of the section is
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.