The rate of heat flow between a solid wall and a fluid (in contact with a solid wall) is given by

Related MCQs

• The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m-1.°C1 respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m-2 .°C-1 . The rate of heat loss from the outer surface in W.m-2 is
• Fluid motion in the natural convection heat transfer between a solid surface and a fluid in contact with it, results from the
• The face temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of wall material is 0.30 kcal/m-hr-?C. For a wall thickness of 20 cm, the rate of heat conduction per square meter of wall area will be
• 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2 .s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2 /1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid).
• The rate of heat loss through a furnace wall is 1000 kcal per hour when inside temperature is 1000?C and outside wall temperature is 500?C. What should be the wall thickness in case the thermal conductivity of wall material is 0.5 kcal/m-hr?C
• A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2 .°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be
• A dimensionless heat transfer coefficient which gives a measure of the ratio of the heat transfer rate to the rate at which heat would be conducted within the fluid under a temperature gradient is known as
• A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to
• A liquid to liquid counterflow heat exchanger is used to heat cold fluid from 50?C to 150?C. Assuming that the hot fluid enters at 250?C and leaves at 200?C, the log mean temperature difference for the heat exchanger will be closer to
• For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is