In a reheat Rankine cycle steam with enthalpy of 3300 kJ/kg is expanded in h.p turbine to a state where enthalpy is 2650 kJ/kg. The steam is further expnaded from a state where enthalpy is 2950 kJ/kg to enthalpy of 2525 kJ/kg & latent heat of 2201 kJ.kg. The work of the cycle & amount of reheat respectively are

Related MCQs

• A steam power plant working on Rankine cycle produces steam in the boiler at a rate of 100 kg/s with enthalpy of 3280 kJ/kg from water whose total heat content is 420 kJ/kg. The plant has Rankine efficiency of 24.65 while pump requires 5 kJ/kg of work. The turbine generates power of
• A Rankine cycle has efficiency of 19.4%. The steam enters the turbine with enthalpy of 32.85 kJ/Kg while heat of water entering the boiler is 423.6 kJ/Kg.the work of the turbine is 560 kJ/ Kg. the pump work is
• Considerfollowing options for a simple Rankine cycle i) increasing pressure at exist of turbine ii) increasing average temperature of heat addition iii) decreasing pressure at exit of turbine iv) superheating of steam v) decreasing pressure during superheating. Which combination of above will increase Rankine efficiency?
• Correlate the following statements i) the volume of water into which steam is condensed in condenser is very much smaller than the volume of steam before condensation ii) the net work of a Rankine cycle is heat supplied in boiler - heat rejected to condenser - pump work
• In a simple Rankine cycle steam was expanded from 100 bar & 380°C to 1 bar 0.8 dry state. The pump motor consumes 10 kJ/kg of energy. The efficiency of cycle is
• A simple Rankine cycle produces 40 MW of power, 50 MW of process heat and rejects 60 MW of heat to the surroundings. What is the utilization factor of this co generation cycle neglecting the pump work?
• The temperature of feed water can be increased in following two ways in a regenerative Rankine cycle i) by passing feed water around turbine casing in direction opposite to flow of steam ii) by bleeding certain portion of steam at the end of h.p expansion & mixing with condensate to make feed water at the temperature of boiler
• In a regenerative Rankine cycle as compared to simple Rankine cycle
• A heat engine is supplied with 250 kJ/s of heat at a constant fixed temperature of 227°C. The heat is rejected at 27°C. The cycle is reversible, if the amount of heat rejected is
• A Rankine cycle with reheat