In hot riveting the shank portion is subjected to compressive stress.

Related MCQs

• Cold riveting holds the connected parts better than hot riveting.
• Thickness of plate is required more in welding than in riveting.
• In hand riveting die is a part of hammer.
• Riveting is not recommended for aluminium alloys.
• In joining steel plate and asbestos, welding is preferred over riveting.
• If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.
• Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
• Stress intensity factor is the critical value of stress at which crack extension occurs.
• A curved beam with eccentricity 0.02D is loaded with 1kN.Centroidal radius=4D and inner and outer radii are 3.5D and 4.5D respectively. Area of cross section is 0.8D². Find the dimension D if allowable stress is 110N/mm² and considering only direct tensile stress.
• Cotter joint is used when the members are subjected to which type of stresses?