

McqMate
These multiple-choice questions (MCQs) are designed to enhance your knowledge and understanding in the following areas: Civil Engineering .
151. |
Which cement is used for works economic where considerations is predominant? Reservoirs, retaining walls, swimming pools, dams, bridges, piers etc. |
A. | Waterproof Portland Cement |
B. | Colored Cement |
C. | High Alumina Cement |
D. | Blast Furnace Slag Cement |
Answer» D. Blast Furnace Slag Cement |
152. |
How many times in each layer of concrete rodded in a slump cone? |
A. | 75 |
B. | 25 |
C. | 12 to 15 |
D. | 35 to 65 |
Answer» B. 25 |
153. |
If L1=Measurement taken after 24 hours of immersion in water at a temp. of 27 ± 20oC and L2=Measurement taken after 3 hours of immersion in water at boiling temperature. Then what is soundness of cement? |
A. | L1+L2 |
B. | L1/L2 |
C. | L1-L2 |
D. | L1*L2 |
Answer» C. L1-L2 |
154. |
Which of the following option is correct? |
A. | Standard consistency (%) = (wt of water added/ wt of cement) *100 |
B. | Standard consistency (%) = (wt of water added- wt of cement) *100 |
C. | Standard consistency = (wt of water added/ wt of cement) *100 |
D. | Standard consistency (%) = (wt cement/ wt of water) *100 |
Answer» A. Standard consistency (%) = (wt of water added/ wt of cement) *100 |
155. |
According to geological origin, aggregates is/are classified into __________ types. |
A. | 1 |
B. | 2 |
C. | 3 |
D. | 4 |
Answer» B. 2 |
156. |
Crushed stone, gravel and ordinary sand are examples of ___________ |
A. | Lightweight aggregate |
B. | Normal-weight aggregate |
C. | Heavy-weight aggregate |
D. | Both Normal-weight aggregate and Heavy-weight aggregate |
Answer» B. Normal-weight aggregate |
157. |
Which type of aggregate is shown below? |
A. | Angular aggregate |
B. | Rounded aggregate |
C. | Flaky aggregate |
D. | Irregular or partially aggregate |
Answer» C. Flaky aggregate |
158. |
The rock which is not calcareous, is : |
A. | lime stone |
B. | Macl |
C. | Chalk |
D. | Laterite |
Answer» D. Laterite |
159. |
The main object of compaction of concrete, is: |
A. | to eliminate air holes |
B. | to achieve maximum density |
C. | to provide initimate contact between the concrete and embedded materials |
D. | all the above. |
Answer» D. all the above. |
160. |
Grading of aggregates should be continuous for |
A. | lean |
B. | rich |
Answer» A. lean |
161. |
The aggregates of |
A. | irregular |
B. | angular |
C. | rounded |
D. | flaky |
Answer» B. angular |
162. |
Which of the following ingredient of cement when added in excess quantity, causes the cement to set slowly? |
A. | Lime |
B. | silica |
C. | alumina |
D. | iron oxide |
Answer» B. silica |
163. |
An aggregate having all the pores filled with water but having dry surface is called |
A. | very dry aggregate |
B. | dry aggregate |
C. | saturated surface dry aggregate |
D. | moist aggregate |
Answer» C. saturated surface dry aggregate |
164. |
The internal friction between the ingredients of concrete is minimised by |
A. | adopting coarse aggregates |
B. | using more water |
C. | reducing the surface area |
D. | all of these |
Answer» D. all of these |
165. |
The light-weight concrete is prepared by |
A. | mixing Portland cement with sawdust in specified proportion in the concrete |
B. | using coke-breeze, cinder or slag as aggregate in the concrete |
C. | mixing aluminium in the concrete |
D. | none of tha above |
Answer» B. using coke-breeze, cinder or slag as aggregate in the concrete |
166. |
For compacting plain concrete or one-way reinforced concrete floors, the vibrator used is |
A. | internal vibrator |
B. | screed vibrator |
C. | form vibrator |
D. | all of these |
Answer» B. screed vibrator |
167. |
The surface moisture of aggregates increases the water-cement ratio in the mix and thus |
A. | increases |
B. | decreases |
Answer» B. decreases |
168. |
For compacting large sections of mass concrete in structures, the type of vibrator used is |
A. | internal vibrator |
B. | screed vibrator |
C. | both (a) and (b) |
D. | either (a) or (b) |
Answer» A. internal vibrator |
169. |
The presence of |
A. | sodium carbonate and bicarbonate |
B. | calcium chloride |
C. | sodium chloride |
D. | sodium sulphate |
Answer» A. sodium carbonate and bicarbonate |
170. |
The tetra calcium alumino ferrite in cement has |
A. | good |
B. | poor |
Answer» B. poor |
171. |
For reinforced concrete, the aggregate used is |
A. | sand |
B. | gravel |
C. | crushed rock |
D. | all of these |
Answer» D. all of these |
172. |
The lime concrete has |
A. | less |
B. | more |
C. | same |
Answer» A. less |
173. |
The steel mould used for slump test is in the form of a |
A. | cube |
B. | cylinder |
C. | frustrum of a cone |
D. | none of these |
Answer» C. frustrum of a cone |
174. |
In order to avoid segregation, the concrete should not be thrown from a height. |
A. | Agree |
B. | Disagree |
Answer» A. Agree |
175. |
Water cement ratio may be defined as the ratio of |
A. | volume of water to that of cement in a concrete mix |
B. | weight of water to that of cement in a concrete mix |
C. | volume of water to that of concrete in a concrete mix |
D. | weight of water to that of concrete in a concrete mix |
Answer» B. weight of water to that of cement in a concrete mix |
176. |
Low heat cement contains more lime than ordinary Portland cement. |
A. | True |
B. | False |
Answer» B. False |
177. |
For concreting of tunnel lining, the concrete is transported by |
A. | pumps |
B. | pans |
C. | wheel barrows |
D. | containers |
Answer» A. pumps |
178. |
For the improvement of workability of concrete, the shape of aggregate recommended is |
A. | irregular |
B. | angular |
C. | round |
D. | flaky |
Answer» C. round |
179. |
Which of the following statement is correct? |
A. | Larger the size of coarse aggregate, lesser is the quantity of fine aggregate and of cement required. |
B. | If very dry aggregates are used, the workability of the mix is likely to be reduced |
C. | Bulking is caused due to the formation of thin film of surface moisture around the sand particles. |
D. | all of the above |
Answer» D. all of the above |
180. |
For a structure subjected to the action of sea water, the cement used is |
A. | rapid hardening cement |
B. | low heat cement |
C. | high alumina cement |
D. | sulphate resisting cement |
Answer» C. high alumina cement |
181. |
For high degree of workability, the slump value should vary between |
A. | 0 to 25 mm |
B. | 25 to 50 mm |
C. | 50 to 80 mm |
D. | 80 to 100 mm |
Answer» D. 80 to 100 mm |
182. |
The term 'ware-hourse pack' means |
A. | the total capacity of ware-house |
B. | packing of ware-house |
C. | pressure compaction of bags on lower layers |
D. | pressure exertion of bags on upper layers |
Answer» C. pressure compaction of bags on lower layers |
183. |
The length of Vicat plunger in Vicat's apparatus varies from |
A. | 20 to 30 mm |
B. | 30 to 40 mm |
C. | 40 to 50 mm |
D. | 50 to 60 mm |
Answer» C. 40 to 50 mm |
184. |
The cement concrete prepared by mixing aluminium in it, is called |
A. | air-entrained concrete |
B. | cellular concrete |
C. | aerated concrete |
D. | any one of the above |
Answer» D. any one of the above |
185. |
Plain cement concrete is strong in taking |
A. | tensile stress |
B. | compressive stress |
C. | shear stress |
D. | all of these |
Answer» B. compressive stress |
186. |
As per IS : 459-1978, the concrete mixes are designated into |
A. | 4 grades |
B. | 5 grades |
C. | 6 grades |
D. | 7 grades |
Answer» D. 7 grades |
187. |
The factor which effect the quality of compaction, is |
A. | density of concrete |
B. | strength of concrete |
C. | durability of concrete |
D. | all of these |
Answer» D. all of these |
188. |
The top diameter, bottom diameter and height of the mould used for slump test are respectively |
A. | 100 mm, 200 mm, 300 mm |
B. | 200 mm, 100 mm, 300 mm |
C. | 200 mm, 300 mm, 100 mm |
D. | 100 mm, 300 mm, 200 mm |
Answer» A. 100 mm, 200 mm, 300 mm |
189. |
The aggregate which pass through 75 mm IS sieve and entirely retain on 4.75 mm IS sieve is known as |
A. | cyclopean aggregate |
B. | coarse aggregate |
C. | fine aggregate |
D. | all-in-aggregate |
Answer» B. coarse aggregate |
190. |
The rate of hydration is |
A. | directly |
B. | inversely |
Answer» A. directly |
191. |
Weight batching is done by |
A. | spring dial scale |
B. | platform weighing machine |
C. | portable weigh batchers |
D. | all of these |
Answer» D. all of these |
192. |
The first compound which reacts with water when mixed with cement is tricalcium aluminate. |
A. | Correct |
B. | Incorrect |
Answer» A. Correct |
193. |
An aggregate which may contain some moisture in the pores but having dry surface is known as |
A. | very dry aggregate |
B. | dry aggregate |
C. | saturated surface dry aggregate |
D. | moist aggregate |
Answer» B. dry aggregate |
194. |
Proper curing of cement concrete, is good for its |
A. | volume stability |
B. | strength |
C. | wear resistance |
D. | all of these |
Answer» D. all of these |
195. |
Hydration of cement is due to the chemical action of water with |
A. | dicalcium silicate |
B. | tricalcium silicate |
C. | tricalcium aluminate |
D. | all of these |
Answer» D. all of these |
196. |
The cement concrete in which high compressive stresses are artificially induced before its actual use, is called |
A. | plain cement concrete |
B. | reinforced cement concrete |
C. | prestressed cement concrete |
D. | lime concrete |
Answer» C. prestressed cement concrete |
197. |
The fineness modulus of an aggregate is roughly proportional to |
A. | specific gravity of the aggregate |
B. | shape of the aggregate |
C. | average size of particles in the aggregate |
D. | grading of the aggregate |
Answer» C. average size of particles in the aggregate |
198. |
The water used for ordinary concrete is equal to 5% by weight of aggregate plus |
A. | 10% |
B. | 20% |
C. | 30% |
D. | 40% |
Answer» C. 30% |
199. |
Which of the following statement is wrong? |
A. | The concrete can not be pumped. |
B. | The concrete should have maximum creep. |
C. | The concrete structures can be put to use immediately ater their construction. |
D. | all of the above |
Answer» D. all of the above |
200. |
The sound absorption coefficient of light weight concrete is nearly |
A. | twice |
B. | three times |
C. | four times |
D. | six times |
Answer» A. twice |
Done Studing? Take A Test.
Great job completing your study session! Now it's time to put your knowledge to the test. Challenge yourself, see how much you've learned, and identify areas for improvement. Don’t worry, this is all part of the journey to mastery. Ready for the next step? Take a quiz to solidify what you've just studied.