In lathes, milling and grinding machines which motor will preferred?

Related MCQs

• In cloth washing machines and refrigerators which motors are preferred?
• An I.M. moror is preferred to a D.C. motor because of its-----
• A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The armature resistance is 0.2Ω and contact drop per brush is 1V. What is the full load speed of the motor?
• A 4 pole, 250V series motor has a wave connected armature with 1254 conductors. The flux per pole is 22mWb when the motor taking 50A. Iron and friction lossses amount to 1000W. Armature resistance 0.2Ω, series field resistance 0.2Ω. What is the speed of the motor___.
• A 4 pole, 250V series motor has a wave connected armature with 1254 conductors. The flux per pole is 22mWb when the motor taking 50A. Iron and friction lossses amount to 1000W. Armature resistance 0.2Ω, series field resistance 0.2Ω. What is the output power in H.P.
• A 440V, 20HP, 3phase motor operates at full load, 88% efficiency and 0.65 power factor lagging, the current drawn by motor is
• A 3 phase induction motor connected from a 3 pjhase, 50Hz AC supply runs at 720rpm and has slip 4%. The number of poles in motor are _____.
• If the back emf in a dc motor varnishes suddenly, then the motor:
• A thick wire is used in dc series motor field winding than that in dc shunt motor:
• A DC shunt motor is driving a constant torque load. On inserting an additional resistance in the armature circuit, the speed of the motor will: