Number of tappings for each equilizer ring is equal to

Related MCQs

• Equilizer rings are required in case armature is
• When two D.C. series generators are running in parallel, an equilizer bar is used
• When two D.C. generators are running in parallel an equilizer bar is used
• In case of D.C. machine winding, number of commutator segments is equal to
• For a D.C. generator when the number of poles and the number of armature conductors is fixed, then which winding will give the higher e.m.f. ?
• Two generators A and B have 6-poles each. Generator A has wave wound armature while generator B has lap wound armature. The ratio of the induced e.m.f. is generator A and B will be
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• In lap winding, the number of brushes is always
• The number of brushes in a commutator depends on
• In a D.C. generator the number of mechanical degrees and electrical degrees will be the same when