[Solved] When two D.C. generators are running in parallel an equilizer bar is used

McqMate

Q.	When two D.C. generators are running in parallel an equilizer bar is used
A.	to increase the series flux
B.	to increase the generated e.m.f.
C.	to reduce the combined effect of ar-mature reaction of both the machines
D.	so that the two identical machines will pass approximately equal currents to the load
Answer» D. so that the two identical machines will pass approximately equal currents to the load

5.2k

0

Do you find this helpful?

25

View all MCQs in

Discussion

No comments yet

Related MCQs

When two D.C. series generators are running in parallel, an equilizer bar is used
Two generators are running in parallel. One of the generators may run as motor for which of the following reasons ?
Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
For the parallel operation of two or more D.C. compound generators, we should ensure that
The essential condition for parallel operation of two D.C. generators is that they have
Equilizer rings are required in case armature is
Number of tappings for each equilizer ring is equal to
Which of the following generators will be preferred if they are required to be run in parallel ?
Shunt generators are most suited for stable parallel operation because of their
The main factor which leads to unstable parallel operation of flat and over compounded generators is