What is the effect of decrease of reheat pressure on the quality of steam at turbine exhaust?

Related MCQs

• In a reheat Rankine cycle steam with enthalpy of 3300 kJ/kg is expanded in h.p turbine to a state where enthalpy is 2650 kJ/kg. The steam is further expnaded from a state where enthalpy is 2950 kJ/kg to enthalpy of 2525 kJ/kg & latent heat of 2201 kJ.kg. The work of the cycle & amount of reheat respectively are
• Considerfollowing options for a simple Rankine cycle i) increasing pressure at exist of turbine ii) increasing average temperature of heat addition iii) decreasing pressure at exit of turbine iv) superheating of steam v) decreasing pressure during superheating. Which combination of above will increase Rankine efficiency?
• The optimum reheat pressure for most of the power plants is how many times of the initial steam pressure?
• Consider the following statements regarding superheating in Rankine Cycles 1. It reduces the specific steam consumption 2. It increases the dryness fraction of steam at the exhaust for the same value of condenser pressure 3. It reduces the cycle efficiency Of the these statements
• What is the effect of reheat pressure on mean temperature of heat addition Tml?
• Steam enters the turbine at 5.44 bar with dryness fraction of 0.9 & is expanded adiabatically to a pressure of 0.68 bar. It will enter the condenser with a quality very close to
• The temperature of feed water can be increased in following two ways in a regenerative Rankine cycle i) by passing feed water around turbine casing in direction opposite to flow of steam ii) by bleeding certain portion of steam at the end of h.p expansion & mixing with condensate to make feed water at the temperature of boiler
• A steam power plant working on Rankine cycle produces steam in the boiler at a rate of 100 kg/s with enthalpy of 3280 kJ/kg from water whose total heat content is 420 kJ/kg. The plant has Rankine efficiency of 24.65 while pump requires 5 kJ/kg of work. The turbine generates power of
• A Rankine cycle has efficiency of 19.4%. The steam enters the turbine with enthalpy of 32.85 kJ/Kg while heat of water entering the boiler is 423.6 kJ/Kg.the work of the turbine is 560 kJ/ Kg. the pump work is
• What is the most preferable dryness fraction of the exhaust steam?