In a turning moment diagram, the variations of energy above and below the mean resisting torque line is called

Related MCQs

• If E = Mean kinetic energy of the flywheel, CS = Coefficient of fluctuation of speed and Δ E = Maximum fluctuation of energy, then
• If bending moment on point B in horizontal plate is M and in vertical plane is m, then the net bending moment at point B is? "The layout of a shaft supported on bearings at A & B is shown. Power is supplied by means of a vertical belt on pulley B which is then transmitted to pulley C carrying a horizontal belt. The angle of wrap is 180’ and coefficient of friction is 0.3. Maximum permissible tension in the rope is 3kN. The radius of pulley at B & C is 300mm and 150mm"
• The ratio of the maximum fluctuation of energy to the ……. is called coefficient of fluctuation of energy.
• A knuckle joint is unsuitable for two rotating shafts, which transmit torque
• Cotter joint can be used to connect two rods for torque transmission purpose.
• Calculate the shaft diameter on rigidity basis if torsional moment is 196000N-mm, length of shaft is 1000mm. Permissible angle of twist per meter is 0.5’ and take G=79300N/mm².
• In order to find the maximum bending moment on the arms, it is assumed as a
• Flexible shafts have              rigidity in bending moment.
• The coefficient of fluctuation of speed is the                    of maximum fluctuation of speed and the mean speed.
• What is mean clearance?