[Solved] The normal range of steel that is radiographed using Ir-192 is:

Q.	The normal range of steel that is radiographed using Ir-192 is:
A.	5 mm–20 mm
B.	25 mm – 75 mm
C.	0.5 mm – 5 mm
D.	75 mm – 150 mm
Answer» B. 25 mm – 75 mm

960

Do you find this helpful?

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

In order to increase latitude so that thick and thin portions may be radiographed at reasonable viewing densities simultaneously:
A 7.6 cm (3 inches) thick test specimen is radiographed with a source having size of 1.3 cm (1/2 inch), the film is placed in contact with the test specimen. The source to film distance is 40.6 cm (16 inches).The geometric unsharpness obtained is:
Radiographic equivalence factors for Inconel and 304 stainless steel are 1.4 and 1.0 respectively. What is the approximate equivalent thickness of Inconel requiring the same exposure as 1.27 cm (½ inch) thickness of 304 stainless steel?
The approximate radiographic equivalence factors for steel and copper at 220 kV are 1.0 and 1.4 respectively. If it is desirable to radiograph a 1.27 cm (0.5 inch) piece of copper, what thickness of steel would require about the same exposure characteristics?
A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
According to ASTM E709-95 in using prod technique on a 50 mm thickness plate with a prod spacing of 101 mm (4 inches), current shall be selected in the following range:
When performing a post emulsifiable penetrant test, the test piece does not rinse acceptable clean during normal processing. What should be done?
In immersion testing, verification that the search unit is normal to a flat entry surface is indicated by:
When a sound beam is incident on an acoustic interface at some angle other than normal incidence, which of the following occurs?
Which of the following chemical elements are normally held to a minimum in liquid penetrant materials, when testing stainless steel and titanium?