Radiographic equivalence factors for Inconel and 304 stainless steel are 1.4 and 1.0 respectively. What is the approximate equivalent thickness of Inconel requiring the same exposure as 1.27 cm (½ inch) thickness of 304 stainless steel?

Related MCQs

• The approximate radiographic equivalence factors for steel and copper at 220 kV are 1.0 and 1.4 respectively. If it is desirable to radiograph a 1.27 cm (0.5 inch) piece of copper, what thickness of steel would require about the same exposure characteristics?
• If an exposure time of 60 seconds and source to film distance of 365.7 m (1200 feet) is necessary for a particular exposure, what exposure time would be needed for an equivalent exposure if the source- to-film distance is changed to 457.2 m (1500 feet)?
• A radiographic exposure with 3700 GBq (100 Ci) source of Ir-192 using source to film distance of 60 cm results in a radiation intensity of 0.12 Gy/h (11.8 R/h) and a radiographic density of 2.5. The intensity of radiation needed to obtain the same density when the source to film distance is changed to120 cm is:
• A radiograph is made using film X with an exposure of 10 mA-min. Film density obtained in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
• A radiograph is made using film X with an exposure of 10 mA-min. Film density in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
• If the required X ray exposure time for a 225 kV, 5 mA exposure is 3 minutes, approximately what exposure time would be required at 10 mA?
• If the required X ray exposure time for a 150 kV, 5 mA exposure is 2 minutes, approximately what exposure time would be required at 10 mA?
• A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
• If we were to maintain the same exposure but decrease the source to film distance, we must the time of exposure:
• In the radiographic analysis procedure that is used to prepare an exposure chart, the first step is to: