[Solved] A change in which of the following parameters would require a new X ray exposure chart?

Q.	A change in which of the following parameters would require a new X ray exposure chart?
A.	kV
B.	Required film density
C.	Test piece thickness
D.	All of the above
Answer» B. Required film density

Do you find this helpful?

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

A change in which the following parameters would require a new X ray exposure chart?
A change in which of the following parameters would necessitate the construction of a new X ray exposure chart?
If the required X ray exposure time for a 225 kV, 5 mA exposure is 3 minutes, approximately what exposure time would be required at 10 mA?
If the required X ray exposure time for a 150 kV, 5 mA exposure is 2 minutes, approximately what exposure time would be required at 10 mA?
If an exposure time of 60 seconds and source to film distance of 365.7 m (1200 feet) is necessary for a particular exposure, what exposure time would be needed for an equivalent exposure if the source- to-film distance is changed to 457.2 m (1500 feet)?
A radiograph is made using film X with an exposure of 10 mA-min. Film density obtained in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
A radiograph is made using film X with an exposure of 10 mA-min. Film density in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
If the required exposure time for a 2220 GBq (60 curie) Ir-192 source is 2 minutes, what exposure time would be required at 1110 GBq (30 curie) source:
If the required exposure time for a 1850 GBq (50 curie) Ir-192 source is 4 minutes, what exposure time would be required for 925 GBq (25 curie) source: