[Solved] Which of the following techniques would probably reduce the amount of scattered radiation reaching the film during a radiographic exposure?

Q.	Which of the following techniques would probably reduce the amount of scattered radiation reaching the film during a radiographic exposure?
A.	Using a finer grained film
B.	Masking the test piece
C.	Removing lead screens
D.	All of the above
Answer» B. Masking the test piece

4.1k

Do you find this helpful?

View all MCQs in

Non Destructive Testing and Evaluation

Discussion

No comments yet

Related MCQs

Which of the following techniques would probably reduce the amount of back scattered radiation reaching the film during a radiographic exposure?
Which of the following techniques would probably reduce the amount of scattered radiation reaching the film during a radiographic exposure?
A radiographic exposure with 3700 GBq (100 Ci) source of Ir-192 using source to film distance of 60 cm results in a radiation intensity of 0.12 Gy/h (11.8 R/h) and a radiographic density of 2.5. The intensity of radiation needed to obtain the same density when the source to film distance is changed to120 cm is:
If an exposure time of 60 seconds and source to film distance of 365.7 m (1200 feet) is necessary for a particular exposure, what exposure time would be needed for an equivalent exposure if the source- to-film distance is changed to 457.2 m (1500 feet)?
A radiograph is made using film X with an exposure of 10 mA-min. Film density obtained in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
A radiograph is made using film X with an exposure of 10 mA-min. Film density in the area of interest is 1.0. If it is desired to achieve a density of 2.0 in the area of interest, what exposure is required? (Log relative exposure = 1.1 for a density of 1.0 and 1.62 for a density of 2.0)
A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
Most scattered radiation which adversely affects the radiographic image quality originates:
A low density image of the letter ‘B’ on a radiographic film would probably be caused by:
A radiographic indication in a weld, characterised by two parallel dark lines in the film image, would probably be caused by: