Which of the following statements regarding an idel single-phase transformerhaving a turn ratio of 1 : 2 and drawing a current of 10 A from 200 V A.C. supply is incorrect ?

Related MCQs

• In a step-down transformer, there is a change of 15 A in the load current. This results in change of supply current of
• The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• The no-load current drawn by transformer is usually what per cent of the full-load current ?
• The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be
• A shunt generator running at 1000 r.p.m. has generated e.m.f. as 200 V. If thespeed increases to 1200 r.p.m., the generated e.m.f. will be nearly
• The voltage transformation ratio of a transformer is equal to the ratio of
• Which of the following is not the standard voltage for power supply in India ?
• If the supply voltage for a D.C. motor is increased, which of the following willdecrease ?
• Which of the following loss in a D.C. generator varies significantly with the load current ?