Which of the following is not the standard voltage for power supply in India ?

Related MCQs

• For given applied voltage, with the increase in frequency of the applied voltage
• If a transformer is switched on to a voltage more than the rated voltage
• A sinusoidal voltage of 5 Hz is applied to the field of a shunt generator. The armature voltage wave
• The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be
• The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage
• If the supply voltage for a D.C. motor is increased, which of the following willdecrease ?
• The highest voltage for transmitting electrical power in India is
• A transformer cannot raise or lower the voltage of a D.C. supply because
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• Minimum voltage regulation occurs when the power factor of the load is