The starting resistance of a D.C. motor is generally

Related MCQs

• By looking at which part of the motor, it can be easily confirmedthat a particular motor is D.C. motor?
• Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be
• If R2 is the resistance of secondary winding of the transformer and K is the transformation ratio then the equivalent secondary resistance referred to primary will be
• In a D.C. generator the critical resistance refers to the resistance of
• The critical resistance of the D.C. generator is the resistance of
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• For starting a D.C. motor a starter is required because
• For the same H.P. rating and full load speed, following motor has poor starting torque
• Following motor is used where high starting torque and wide speed range control is required.
• As there is no back e.m.f. at the instant of starting a D.C. motor, in order to prevent a heavy current from flowing though the armature circuit