The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than

Related MCQs

• The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or
• If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by
• The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
• The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of
• If the average bending stress is 6 kg/cm2 for M 150 grade concrete, the length of embedment of a bar of diameter d according to I.S. 456 specifications, is
• If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than
• If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
• If diameter of a reinforcement bar is d, the anchorage value of the hook is
• In the zone of R.C.C. beam where shear stress is less than 5 kg/cm2 , nominal reinforcement is provided at a pitch of
• Minimum spacing between horizontal parallel reinforcement of the same size should not be less than