McqMate

Q. |
## The ratio of heat utilised to produce steam and the heat liberated in furnace is known as |

A. | boiler effectiveness |

B. | boiler evaporative capacity |

C. | factor of evaporation |

D. | boiler efficiency. |

Answer» D. boiler efficiency. |

2.3k

0

Do you find this helpful?

9

View all MCQs in

Thermal Engineering 1No comments yet

- The latent heat of steam at pressures greater than atmospheric in comparison to latent heat at atmospheric pressure is
- In an experiment to determine dryness fraction of steam, the mass of water separated was 1.2 kg in 15 minutes and the mass of steam passed out in same time was 4.8 kg. Dryness fraction is
- One kg of steam sample contains 0.8 kg dry steam; it's dryness fraction is
- In a velocity-compounded impulse steam turbine, steam expands in
- In a pressure-compounded impulse steam turbine, steam expands in
- It is required to produce large amount of steam at low pressure. Which boiler should be used ?
- The latent heat of steam with increase of pressure
- The balanced draft furnace is one using
- Heating of dry steam above saturation temperature is known as
- A condenser where circulating water flows through tubes which are surrounded by steam,is known as.........