A beam of rectangular cross-section is 100 mm wide and 200 mm deep. If the section is subjected to a shear force of 20 kN, then the maximum shear stress in the section is

Related MCQs

• A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
• A rectangular block of size 200 mm x 100 mm x 50 mm is subjected to a shear stress of 100 N/mm2. If modulus of rigidity of material is 1 x 105 N/mm2, strain energy stored will be
• The ratio of maximum shear stress to the average shear stress in a rectangular beam subjected to torsion is
• A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be
• A beam of square cross-section with side 100 mm is placed with one diagonal vertical. If the shear force acting on the section is 10 kN, the maximum shear stress is
• A simply supported beam with rectangular cross-section is subjected to a central concentrated load. If the width and depth of the beam are doubled, then the deflection at the centre of the beam will be reduced to
• A beam of T-section is subjected to a shear force of F. The maximum shear force will occur at the
• A body is subjected to a direct tensile stress of 300 Mpa in one plane accompanied by a simple shear stress of 200 Mpa. The maximum normal stress will be
• A flitched beam consists of a wooden joist 150 mm wide and 300 mm deep strengthened by steel plates 10 mm thick and 300 mm deep one on either side of the joist. If modulus of elasticity of steel is 20 times that of wood, then the width of equivalent wooden section will be
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _