For no torsion, the plane of bending should

Related MCQs

• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• A prismatic beam fixed at both ends carries a uniformly distributed load. The ratio of bending moment at the supports to the bending moment at mid-span is
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• The shear stress at the outermost fibres of a circular shaft under torsion is
• Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D / 2. The strength of hollow shaft in torsion is
• The shear stress at the centre of a circular shaft under torsion is
• When a shaft is subjected to torsion, the shear stress induced in the shaft varies from