McqMate

Q. |
## The ratio of friction torque for uniform pressure to uniform wear for the same dimensions and load is _______. |

A. | >1 |

B. | 1 |

C. | <1 |

D. | (1/2) |

Answer» A. >1 |

1.7k

0

Do you find this helpful?

13

View all MCQs in

Theory of MechanicsNo comments yet

- For flat and conical pivots, the ratio of friction torque with uniform wear to friction torque with uniform pressure is ____.
- The ratio of friction torque transmitted for uniform pressure to frictional torque transmitted for uniform wear in case of flat pivot, is equal to_______.
- The ratio of friction torque for uniform pressure to uniform were for the same dimensions and load is _____________.
- The ratio of frictional torque produced for uniform wear to frictional torque produced for uniform pressure is ____.
- A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1. The friction torque and frictional power in watts with uniform wear are respectively.
- A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1.The friction torque and frictional power in watts with uniform pressure are respectively.
- The ratio of frictional torque produced for uniform wear to that for uniform pressure is ____.
- A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
- A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
- For uniform wear, the ratio of frictional torque for a flat collar bearing to the frictional torque for conical collar bearing is equal to____. Where ϴ=semi-angle of the cone