In a simple bending of beams, the stress in the beam varies

Related MCQs

• Two beams carrying uniformly distributed load have same depth but beams A has width 2nd as compared to width w for beam B. The ratio of elastic strength of beam A compred to that of B will be
• In a beam of uniform strength, the bending stress developed is constant and is equal to the allowable stress at every section of the beam.
• In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that.
• In the simple bending theory one of the assumptions usually made is that the plane sections before bending remain plane after bending. This assumption implies that
• Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending.
• The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
• The bending moment diagram for a cantilever beam subjected to bending moment at the end of the beam would be
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• At a point in a steel member, the major principal stress is 2000 kg/cm2 and the minor principal stress is compressive. If the uni-axial tensile yield stress is 2500 kg/cm2, then the magnitude of the minor principal stress at which yielding will commence, according to the maximum shearing stress theory, is
• If the section modulus of a beam is increased, the bending stress in the beam will