For a 25 mm hole drilled in plates, the diameter of rivet shank should be

Related MCQs

• For riveting, the size of hole drilled in plates is
• The size of hole drilled in plates for rivetting is
• If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
• A flat carrying a pull of 69C kN is con-nected to a gusset plate using rivets. If the pulls required to shear the rivet, to crush the rivet and to tear the plate per pitch length are 68.5 kN, 46 kN and 69 kN respectively, then the number of rivets required is
• The distance between the centre of a rivet hole to the nearest edge of plate, is called
• A hole, one metre from the end of a structural steel member, is 0.8 mm shy of matching another hole for possible connection. What force, in kN, is necessary to stretch it for connection? The cross section is 25 mm x 3 mm
• When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as
• Two shafts 'A' and 'B' have the same material. The shaft 'A' is solid of diameter 100 mm. The shaft 'B' is hollow with outer diameter 100 mm and inner diameter 50 mm. The torque transmitted by shaft 'B' is
• Two shafts 'A' and 'B' are made of same material. The shaft 'A' is solid and has diameter D. The shaft 'B' is hollow with outer diameter D and inner diameter D / 2. The strength of hollow shaft in torsion is
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be