The size of hole drilled in plates for rivetting is

Related MCQs

• For riveting, the size of hole drilled in plates is
• For a 25 mm hole drilled in plates, the diameter of rivet shank should be
• A hole, one metre from the end of a structural steel member, is 0.8 mm shy of matching another hole for possible connection. What force, in kN, is necessary to stretch it for connection? The cross section is 25 mm x 3 mm
• When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as
• While punching a hole in a metal sheet using a punch, stress is developed in the metal sheet.
• While punching a hole in a metal sheet using a punch, stress is developed in the Punch.
• If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
• The distance between the centre of a rivet hole to the nearest edge of plate, is called
• For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
• The force required to punch a 25 mm hole in a mild steel pipe 10 mm thich, when ultimate shear stress of the plate is 500 N/mm2 will be nearly